1-inch Minotaur In-fit cubes for 3x5 inch index cards.
In-Fit Print&Play cubes: easy-to-assemble and (optionally) disassemble for flat storage -- http://www.boardgamegeek.com/thread/408447


Included are shaded and unshaded (ink-sipper) patterns for Minotaur! cubes, with better-aligned corridors, now more exactly 1" across, in the new, easier-to-make 3-sleeve format. (For completeness, the older 2-sleeve format of the patterns is also included.)

Version 2: tidied up, put inner sleeve end tab in less visible position. Inspired by hrhtomas's PNP cubes (see http://www.boardgamegeek.com/image/352115), these cubes for Minotaur! use GornoTech's two-part in-fit cube design (see http://www.boardgamegeek.com/thread/408447 )
for easy cut-out and assembly, plus (optional) flattenable disassembly. You may not need to cut off the superfluous "X" side tabs, but to most easily remove them, nick and fold the side tabs so the interior cut to detach the X-tab becomes an exterior cut you can make with a scissors.

Inspired by hrhtomas's PNP cubes (see http://www.boardgamegeek.com/image/352115), these cubes for Minotaur! use GornoTech's two-part in-fit cube design for easy cut-out and assembly, plus (optional) flattenable disassembly.